15 BA_KA-ED_A22_190313_en.doc
Fig. 5
Cutting position: (Fig. 6):
After the looper has taken up the loop, the looper needs to be moved so far so that
the thread of the loop on the needle side hangs on the cloth retainer and the other
side slides in the groove of the cloth retainer. This way the loop half to be cut is placed
on the cutter and is cut across the blade when the carriage retracts.
Fig. 6
This can be simulated by stopping the machine in the stitch with button 1 of the
operating control V810 and activating the solenoid 1V1 by hand. Now the coupling has
to be switched off by toggle switch S6 (Fig. 10) and the carriage pushed back by hand a
little.
To Next Page
Loading...
