www.stryker.com 6506-209-001 REV F 19
Setup
During setup, unpack the cartons and check all items for proper operation. Make sure that the product operates before
you place it into service.
WARNING
Always install the in-fastener shut-off system in any emergency vehicle that will be used with this cot if using an antler
style cot fastener.
Remove all the shipping and packaging materials from the product before use.
The vehicle patient compartment where the product will be used must have a:
• Smooth rear edge for product loading
• Level floor large enough for the folded product
• Stryker cot fastener system
• Space to install the vehicle safety hook
• In fastener shut-off module installed, if using an antler style cot fastener
Note: Loose items or debris on the vehicle patient compartment floor can interfere with the operation of the vehicle
safety hook and product fastener. Keep the vehicle patient compartment floor clear.
Unpack the SMRT Paks and SMRT charger. Charge the SMRT Pak before use.
When necessary, modify the vehicle to fit the cot. Do not modify the cot.
To Next Page
Loading...
