www.stryker.com 6506-209-001 REV F 65
Operation
Installing the charger onto the optional mounting bracket (Continued)
Figure 53: Installing the charger
Powering the charger
CAUTION
• Always place the electrical SMRT charger power cord where it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
• Do not touch the SMRT Pak receptacle terminals with metal objects.
To power the SMRT charger (Figure 54 on page 66):
1. Locate the power connection (A) on the back of the SMRT charger.
2. Push the power cord retention tab (B) in to insert the power cord outlet connector into the SMRT charger power
connection.
3. Plug the power adaptor end of the power cord into the power source.
To Next Page
Loading...
