Stryker Power-PRO XT - Raising, Lowering, or Releasing the Cot with Power

www.stryker.com 6506-209-001 REV F 31
Operation
Raising or lowering the cot (Continued)
To raise or lower the cot:
1. Operator 1 (foot end): Grasp the cot frame and press the:
• Extend (+) button to raise the cot to the desired height
• Retract (-) button to lower the cot to the desired height
2. Operator 2 (head end): Maintain a firm grip on the outer rail until the cot is at the desired height.
Notes
• Operator 2 is required to raise or lower the cot with a patient.
• If you press the extend (+) button on the cot control switch after the cot reaches the set cot load height, the motor
will remain halted until you release the button. After you release the button, press the extend (+) button again to jog
the cot height up higher.
Raising, lowering, or releasing the cot with power
There are two identical cot control switches located on the Power-PRO cots. Press the button on either of these switches
to raise (extend) the cot, lower (retract) the cot, or release the cot from Power-LOAD, if applicable (Figure 14 on page
31).
A
B
C
Figure 14: Cot control switches
Reference Name Description
A Release
Press to unlock the cot (for use with
Power-LOAD only)
B Retract (-) Press and hold to lower the litter or
retract the cot undercarriage
C
Extend (+) Press and hold to raise the litter or
extend the cot undercarriage