Stryker Secure 3000 - Converting Patient Weight; Changing Displayed Weight Value

Weigh System Usage
28
CONVERTING THE PATIENT’S WEIGHT
 To convert the patient’s weight from pounds to kilograms, press and release ”SCALE ON” to activate
the weigh system. After the scale monitor reads ”XXX.X LB”, press and release the ”LBS/KGS” but-
ton. The scale monitor will read:
”WEIGHT NOW KGS”
”XXX.X KG”
 Repeat the procedure to return to pounds. The display will read:
”WEIGHT NOW LBS”
”XXX.X LB”
CHANGING THE NUMERICAL VALUE OF DISPLAYED WEIGHT
 To decrease the numerical value of the displayed weight, press and hold ”–”. The scale monitor will
read:
”HOLD TO DEC. WT.”
”XXX.X LB”
 Hold ”–” until desired value is achieved.
 To increase the numerical value of the displayed weight, press and hold ”+”. The scale monitor will
read:
”HOLD TO INC. WT.”
”XXX.X LB”
 Hold ”+” until desired value is achieved.
NOTE
The weigh system will shut off approximately one minute after a function has been used, if another function
is not activated. Display light will shut off and display will read ”SCALE OFF”.
The weigh system will retain all patient weight information in its memory even when the scale monitor is off
or when the bed is unplugged from the wall socket.