Maintenance Procedures – Siderail
97
SIDERAIL ASSEMBLY REMOVAL
Required Tools:
#2 Phillips Screwdriver T27 Torx
NOTE
Because of fastener changes, it will be necessary to use either a Phillips screwdriver or a T27 Torx to remove
the bolts securing the litter access cover.
Removal Procedure:
1. Run the head section up electrically when removing a head end siderail.
2. Unplug the bed power cord from the wall socket.
3. Lower the siderail being removed.
NOTE
If removing a head end siderail, the cable must be unplugged from the CPU board under the head end litter
access cover.
4. Using a #2 Phillips screwdriver or a T27 Torx, remove the four screws holding the head end litter access
cover to the litter and remove the cover.
A
B
5. Using a T27 Torx, remove the two screws (A) or (B) holding the siderail assembly on the head or foot
section.
6. Push in on the siderail assembly to clear under the head or foot section and pull the siderail back to re-
move it from the bed.
7. Reverse the above steps to reinstall the siderail assembly.
NOTE
Grease the glide rods on the replacement siderail assembly with Syntech grease.
To Next Page
Loading...
