Stryker SV2 - Page 41

English
EN
www.stryker.com KK-7500 REV 02 1-35
Operation
Inserting or removing a cassette from the X-ray cassette holder (option)
(Continued)
The SV2 may include an optional radiolucent backrest to allow X-ray images to be taken while the patient is on the bed.
You can take X-ray images by inserting an X-ray cassette into the housing that is located behind the backrest. You do
not need to move the patient to insert an X-ray cassette or take an X-ray.
X-ray guide dimensions: 390 mm x 660 mm x 16 mm
The recommended X-ray cassette dimensions are:
• 385 mm x 385 mm x 15 mm
• 460 mm x 383 mm x 15 mm
To insert an X-ray cassette:
1. See Removing or replacing the headboard on page 1-23.
2. Slide the X-ray cassette into the X-ray cassette holder.
3. Adjust the patient to the desired position.
To remove an X-ray cassette:
1. Slide the X-ray cassette out of the X-ray cassette holder.
2. See Removing or replacing the headboard on page 1-23.