Stryker SV2 Service Manual (English)

Other manuals for Stryker SV2

Questions and Answers:

N
Nicole FlynnJul 27, 2025
What to do if Stryker Medical Equipment bed does not operate?
- J
  Jonathan AlexanderJul 27, 2025
  If your Stryker Medical Equipment bed isn't operating, here are a few things to check: * Ensure the power cable is correctly plugged into the mains and is not damaged. If it is damaged, it should be replaced by authorized service personnel. * Check the nurse control unit or hand control unit to ensure they are not locked. The Nurse Control Unit activation button should be inspected (On-Off). * If the control box is not working, it may need to be replaced; in this case, contact technical service.
J
Jonathan StevensonAug 1, 2025
Why Stryker SV2 Medical Equipment actuators move slowly?
- B
  Brandon Lucero IIAug 2, 2025
  If the actuators on your Stryker Medical Equipment are moving slowly, it's possible the bed is running on battery power because the main power is disconnected. Here’s what you should do: 1. Check if the power cable has come out of the control panel. 2. Inspect the power cable connections. 3. Check the socket.
C
Christopher GonzalezAug 6, 2025
What to do if Stryker Medical Equipment control box beeps while actuators are raised?
- J
  Janice RodriguezAug 7, 2025
  If the control box beeps while the actuators are being raised and the actuators won't move downward on your Stryker Medical Equipment, it indicates that the control box actuator position reference has been lost. To resolve this: 1. Unplug the power cord and turn off the battery. 2. Plug in the power cord and turn on the battery. 3. Run each upper actuator to its highest position.
G
Gina DavidsonAug 10, 2025
What to do if Stryker Medical Equipment actuator does not operate and control box gives a click sound?
- R
  Rhonda FosterAug 11, 2025
  If one of the actuators on your Stryker Medical Equipment does not operate and the control box makes a clicking sound, consider the following: * Check the socket connections of the control box to ensure the actuator cable is properly connected. * Inspect the CPR wire and nut adjustment to ensure the CPR wire is not stuck.
B
Benjamin PattersonAug 15, 2025
What to do if Stryker SV2 Medical Equipment actuator does not operate and control box does not give a click sound?
- M
  millermeganAug 16, 2025
  If one of the actuators on your Stryker Medical Equipment fails to operate and the control box doesn't make a clicking sound, here’s what you can check: * Inspect the nurse control unit or hand control to ensure they are not locked. * Unplug the side rail control unit from the socket and check for function with the nurse control unit. If function is restored, there may be a problem with one of the control units. Contact technical service.