Stryker SV2 - Installing the Oxygen Bottle Holder; Installing the Foley Bag Basket

English
EN
www.stryker.com KK-7500 REV 02 1-39
Accessories
Installing the oxygen bottle holder
WARNING
Do not use accessories to support patient limbs or other body parts.
CAUTION
• Always make sure that accessories are locked into position.
• Do not use the oxygen bottle holder as a push or pull device.
• Always turn the oxygen bottle holder in toward the bed before transporting a patient.
• Do not strike the oxygen bottle holder while transporting a patient.
• Do not allow accessories to interfere with mechanical or electric mechanisms of the product.
To install the oxygen bottle holder:
1. Insert the oxygen bottle holder into one of the two accessory sleeves near the head end (Figure 1-27 on page 1-39).
Figure 1-27: Installing the oxygen bottle holder
2. Rotate and lock the oxygen bottle holder into the accessory sleeve (Figure 1-28 on page 1-39).
Figure 1-28: Locking the oxygen bottle holder
Installing the Foley bag basket
WARNING
Do not use accessories to support patient limbs or other body parts.