pg 31
STEP 2 SET MIDI CHANNEL (CONTINUED)
TIME REC LEVEL MIX
TAPE AGE REPEATS MECHANICS
low high
med
hold (tap)
single head dTape echo
4 Press the footswitch to exit and store your MIDI Channel setting and
begin using EC-1�
NOTE: A simple way to check that communication is working is to send CC
#102 with a value of 127 when the footswitch is bypassed� This will enable
the footswitch (and the LED will light RED) if MIDI is properly connected and
configured�
NOTE: If you are only sending data to EC-1 using the Strymon MIDI EXP
cable, the MIDI OUT Mode must be set to OFF� (See page 32 for details on
configuring the MIDI OUT Mode�)
NOTE: MIDI Channel assignment is not saved per Favorite setting or MIDI
preset�
To Next Page
Loading...
