pg 14
Flint - tremolo & reverb
Power Up Modes
Input Level
Select the input level that is routed to the effect processing�
1 Press and hold the REVERB ON footswitch while powering up Flint�
Once both LEDs flash, release the footswitch�
2 Turn the INTENSITY (INPUT LEVEL) knob to select the Input Level
mode� The TREMOLO ON LED will change color to indicate the cur-
rent status as you turn the knob�
• Instrument: GREEN (default) - Input headroom is set for an in-
strument level source, such as a guitar or a bass�
• Line: RED - Input level is set for a line level source, such as a
keyboard or synthesizer� 10dB of headroom is added�
3 Press either footswitch to store the Input Level setting and begin
using Flint�
NOTE: The Input Level setting persists across power cycles and is not saved
per preset�
To Next Page
Loading...
