pg 3
Flint - tremolo & reverb
Knobs and Switches
Front Panel Controls - Tremolo
INTENSITY
Controls the depth of the tremolo effect�
This is accomplished by varying the ampli-
tude of the LFO that controls the tremolo�
At minimum position, the LFO is off and no
tremolo effect is heard, but the signal still
travels through the tremolo “circuit�”
SPEED
Varies the tremolo LFO frequency from
slow to fast� The slow range is extended to
give lower trem speeds than were generally
available in the original, vintage offerings�
TREMOLO ON
Engages and bypasses the tremolo effect�
RED LED on indicates that the effect is
engaged� Bypass mode is true bypass by
default� See page 15 for details�
TREMOLO
Switches between three tremolo modes�
‘61 harm: harmonic band filtering that alternates low and high
frequencies for a hypnotic effect
‘63 tube: a smooth volume pulsing created by modulating the bias
point of the output tubes
‘65 photo: a sharper-edged volume effect achieved by using a
photocell and light-dependent resistor
To Next Page
Loading...
