pg 15
Flint - tremolo & reverb
Power Up Modes
Bypass Mode
Setting Flint to Buffered Bypass mode preserves the high frequency
response of your guitar signal through your pedal chain and long cable
runs�
1 Press and hold the REVERB ON footswitch while powering up Flint�
Once both LEDs flash, release the footswitch�
2 Turn the MIX (BYPASS MODE) knob to choose between True Bypass
or Buffered Bypass modes� The REVERB ON LED will change color
to indicate the current status�
• True Bypass: GREEN (default)�
• Buffered Bypass: RED
3 Press either footswitch to store the Bypass Mode and begin using
Flint�
NOTE: The Bypass Mode setting persists across power cycles and is not
saved per preset�
To Next Page
Loading...
