pg 16
Flint - tremolo & reverb
Power Up Modes
Spillover Mode
Setting Flint to Spillover Mode allows the wet reverb signal of a currently
selected preset to “spill” into bypass or the next selected preset�
NOTE: Because of the buffer architecture, the current preset must be active
for at least 5 seconds before Spillover between presets will be operational�
Spillover is available immediately when bypassing the effect�
1 Press and hold the REVERB ON footswitch while powering up Flint�
Once both LEDs flash, release the footswitch�
2 Turn the DECAY (SPILLOVER MODE) knob to turn Spillover Mode on
or off� Both LEDs will change color to indicate the current status as
you turn the knob�
• Spillover Mode Off: AMBER (default)
• Spillover Mode On: PURPLE
3 Press either footswitch to store the Spillover Mode status and begin
using Flint�
NOTE: The Spillover Mode setting persists across power cycles and is not
saved per preset�
To Next Page
Loading...
