pg 30
Flint - tremolo & reverb
MIDI Functionality (cont.)
Saving Presets in MIDI Mode
When in MIDI mode, the currently loaded settings can be saved to any of
Flint’s 300 preset locations at any time�
1 To enter Save mode, press and hold the TREMOLO ON footswitch� the
TREMOLO ON LED will blink BLUE to indicate that Flint is waiting to
receive a MIDI Program Change message�
2 To save the current state of the pedal to the currently loaded preset
location, press the TREMOLO ON footswitch�
OR
To save the current state of the pedal to any preset location, send
the unit a MIDI Program Change on Flint’s currently selected MIDI
channel� For example:
• Sending MIDI Program Change #10 will save the preset to the
corresponding memory location on the pedal�
• To recall this preset, send MIDI Program Change #10 from your
MIDI controller or sequencer�
NOTE: Press the REVERB ON footswitch to cancel the save operation�
To Next Page
Loading...
