pg 29
Flint - tremolo & reverb
Configuring Flint to Use MIDI (cont.)
STEP 3 SET MIDI OUT MODE
1 Press and hold the TREMOLO ON footswitch while connecting power
to the pedal� Once both LEDs flash, release the footswitch�
2 Turn the DECAY knob to select what kind of MIDI data is sent from
Flint to other MIDI devices� Both LEDs will flash momentarily to indi-
cate status�
• OFF: RED (default) - No MIDI messages are sent out of Flint�
• THRU: BLUE - Incoming MIDI messages are sent to the MIDI Out
without any additional MIDI messages generated by Flint�
• SEND CC, PC, OTHER: WHITE - MIDI CC, PC, and Sysex messages
generated by Flint are all sent to the MIDI Out�
• SEND CC, OTHER: GREEN - MIDI CC and Sysex messages gener-
ated by Flint are sent to the MIDI Out�
• SEND PC, OTHER: PURPLE - MIDI PC and Sysex messages gen-
erated by Flint are sent to the MIDI Out�
• SEND OTHER: AMBER - Sysex messages generated by Flint are
sent to the MIDI Out�
3 Press either footswitch to store the MIDI Out mode and exit�
To Next Page
Loading...
