pg 4
Flint - tremolo & reverb
Knobs and Switches
Front Panel Controls - Reverb
REVERB ON
Engages and bypasses the reverb effect� RED LED on
indicates that the effect is engaged� Bypass mode is true
bypass by default� See page 15 for details�
MIX
Controls the reverb wet mix from full
dry at minimum to full wet with no dry
signal at maximum� 50/50 mix is at the
3 o’clock position�
DECAY
Controls the duration of the reverber-
ated signal’s decay� The ‘70s and ‘80s
verbs will approach “infinite” decay at
maximum�
COLOR
Varies the reverb tone from darker at
low settings, to brighter at higher set-
tings� This is critical for dialing in the
sweet spot in front of a variety of amps�
REVERB
Switches between three different reverb types�
‘60s: full-size two-spring tank typical of those found on
vintage guitar amps
‘70s: electronic plate that uses multi-tap parallel delay
lines with filtered feedback paths
‘80s: studio digital microprocessor rack hall reverb with
modulating delay lines
To Next Page
Loading...
