pg 33
Flint - tremolo & reverb
Factory Reset
Performing a Factory Reset restores the pedal to its factory default
Power-up modes and secondary functions, and replaces all stored pre-
sets with their factory default settings�
1 Press and hold the REVERB ON footswitch while connecting power to
the pedal� Once both LEDs flash, release the footswitch�
2 Sweep the SPEED knob from 0-100% and back two times� Both LEDs
will change colors at the extremes of the knob range and blink RED
to indicate when the reset is taking place�
• TURN 1: AMBER
• TURN 2: RED
• TURN 3: AMBER
• TURN 4: Both LEDs flash RED, Flint resets and restarts�
To Next Page
Loading...
