pg 28
Flint - tremolo & reverb
STEP 2 SET MIDI CHANNEL (CONT.)
4 Press either footswitch to exit and store your MIDI Channel setting
and begin using Flint�
NOTE: A simple way to check that communication is working is to send CC
#10 with a value of 127 when the TREMOLO ON LED is bypassed� This will
enable the TREMOLO ON LED if MIDI is properly connected and configured�
NOTE: If you are only sending data to Flint using the Strymon MIDI EXP
cable, the MIDI Output mode must be set to OFF� (See page 29 for details
on configuring the MIDI Output Mode�)
NOTE: MIDI Channel assignment is not saved per Favorite setting or MIDI
preset�
To Next Page
Loading...
