40
4
INSTALLATIONSTÛV 21
.8 CONVECTION INSTALLATION
Step 62 With the adjustable stands, the
height adjustment is made with a 5 mm
Allen key. Turning clockwise raises the
fireplace.
Step 63 Without the adjustable stands,
legs cans be adjusted at the four corners
inside the combustion chamber. Use a 5
mm Allen wrench or a screwdriver with a 5
mm hex bit to make the adjustment.
Step 59 Secure the grille box to the studs.
Screws are not included.
The air intake grille boxes are smaller than
the hot air grille boxes. Add two pieces of
gypsum ½'' to fill in the empty space.
Step 60 To avoid warping and stress in
the material, insert the screw at 90° in the
studs.
Step 61 It is very important to level the
fireplace after connecting the convection.
Use a level and make the adjustment as
described in the following steps.
6362
61
90 ˚ 90 ˚
60
5
mm
5
mm
PH2
COLD Air
HOT Air
59
PH2
SCREWS NOT INCLUDED
non-combustible
framing
IMPORTANT
The framing around the hot air output
grilles must be non-combustible.
!
To Next Page
Loading...
