Stuv 21 - Unpacking

25
4
INSTALLATIONSTÛV 21
.1 UNPACKING
Step 4 Keep the glass foam to protect
the fireplace cover when removing all the
contents of the combustion chamber,
even refractory bricks and vermiculites.
CONTENT
1. Installation manual
2. Spray paint for touch-ups
3. Hardware bag
4. Fireplace handle
5. Stûv glove
6. 4x Refractory tightening clip*
7. 2x Corner refractory bracket*
8. Refractory bricks
9. 2x Baffle supports
10. Vermiculites
11. Baffle crosspiece (2x for DF models)
Step 1 Using a crowbar, remove the top of
the transport pallet.
Step 2 Then remove each side so that
only the base is left.
Step 3 Using a cutter, carefully cut the
protective plastic at the back of the
fireplace to avoid damaging the front.
IMPORTANT
The paint is not cured. It is therefore
fairly fragile, but it will harden after
being heated several times. Handle the
unit with care.
!
4
321
Inspect the unit.
The warranty does not cover damage
due to transport unless it is reported
within 48 hours after delivery.
!
CHECK LIST
Is the equipment complete
and in good condition?
!
9
11
8
10
1 2
43
7
6
*For 105 and 125 only
x4 x2
x2
5
4