Black plate (237,1)
北米Model "A3170BE-A" EDITED: 2011/ 7/ 12
CAUTION
. Be careful not to pinch your hand
betw een the headrest and the
cargo area cover when you re-
cline the second-row seat.
. Be careful not to scratch the rear
gate stays while extending and
rewinding the cover.
Scratches on the stays c ould
cause leakage of gas from the
stays, which may result in their
inability to hold the rear gate
open.
NOTE
When the head restraint is adjusted at
the rearmost position of the seat with
the seatback leaned back, the head
restraint comes in contact with the
cargo area cover. In this case, raise
the seatback before adjusting the head
restraint.
If the head restraint is correctly fixed in
any of the lock positions, the head
restraint does not contact the cargo
area cover even when the seatback is
reclined.
& To remove the cover
1. Rewind the cover.
2. Pull either sleeve on the end of the
cover housing to shorten the cover’s
length.
3. Take it off the retainer.
& To install the cover housing
1. Remove the cover at the cover hous-
ing retaining part using a flat-head screw-
driver.
2. Pull either sleeve on the end of the
cover housing to shorten the cover’s
length.
Interior equipment 6-15
– CONTINUED –
6
To Next Page
Loading...
