EasyManua.ls Logo

Subaru Tribeca 2012 - Recommended Fluid; Brake Fluid; Checking the Fluid Level

Subaru Tribeca 2012
578 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Black plate (357,1)
Model "A3170BE-A" EDITED: 2011/ 7/ 12
power steering fluid touches the
exhaust pipe, it may cause a bad
smell, smoke, and/or a fire. If
power steering fluid gets on the
exhaust pipe, be sure to wipe it
off.
The power steering fluid expands greatly
as its temperature rises; the fluid level
differs according to fluid temperature.
Therefore, the reservoir tank has two
different checking ranges for hot and cold
fluids.
Check the power steering fluid level
monthly.
1. Park the vehicle on a level surface,
and stop the engine.
2. Check the fluid level of the reservoir
tank.
When the fluid is hot after the vehicle has
been ru n: C heck that the oil level is
between HOT MIN and HOT MAX on
the surface of the reservoir tank.
When the fluid is cool before the vehicle is
run: Check that the oil level is between
COLD MIN and COLD MAX on the
surface of the reservoir tank.
3. If the fluid level is lower than the
applicable MIN line, add the recom-
mended fluid as necessary to bring the
level between the MIN and MAX line.
If the fluid level is extreme low, it may
indicate possible leakage. Consult your
SUBARU dealer for inspection.
& Recommended fluid
Refer to Fluids F12-7.
Brake fluid
& Checking the fluid level
WARNING
. Never let brake fluid contact your
eyes because brake fluid can be
harmful to your eyes. If brake
fluid gets in your eyes, immedi-
ately flush them thoroughly with
clean water. For safety, when
performing this work, wearing
eye protection is advisable.
. Brake fluid absorbs moisture
from the air. Any absorbed moist-
ure can cause a dangerous loss
of braking performance.
. If the vehicle requires frequent
refilling, there may be a leak. If
you suspect a problem, have the
vehicle checked at your SUBARU
dealer.
CAUTION
. When adding brake fluid, be care-
ful not to allow any dirt into the
reservoir.
. Never splash the brake fluid over
painted surfaces or rubber parts.
Maintenance and service 11-17
CONTINUED
11
Information Provided by:

Table of Contents

Related product manuals