Subaru Tribeca 2012 - Using a Flat-Bed Truck; Towing with All Wheels on the Ground

Black plate (331,1)
北米Model "A3170BE-A" EDITED: 2011/ 7/ 12
The f ront tie-down hooks are located
between each of the front tires and the
front bumper.
Rear tie-down hooks:
The rear tie-down hooks are located near
each of the jack-up reinforcements.
WARNING
Use the rear tie-down hooks only for
downward ancho ring. If they are
used to anchor the vehicle in any
other direction, cables may slip off
the hooks, possibly causing a dan-
gerous situation.
& Using a flat-bed truck
This is the best way to transport your
vehicle. Use the following procedures to
ensure safe transportation.
1. Shift the select lever into the “P”
position.
2. Press the parking brake pedal firmly.
3. Secure the vehicle onto the carrier
properly with safety chains. Each safety
chain should be equally tightened and
care must be taken not to pull the chains
so tightly that the suspension bottoms out.
& Towing with all wheels on the
ground
WARNING
. Never turn the ignition switch to
the “LOCK” position while the
vehicle is being towed because
the steering wheel and the direc-
tion of the wheels will be locked.
. Remember that the brake booster
and power steering do not func-
tion when the eng ine is not
running. Because the engine is
turned off, it will ta ke greater
effort to operate the brake pedal
and steering wheel.
In case of emergency 9-17
– CONTINUED –
9
Information Provided by: