EasyManuals Logo

Subaru Tribeca 2012 User Manual

Subaru Tribeca 2012
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #500 background imageLoading...
Page #500 background image
Black plate (351,1)
Model "A3170BE-A" EDITED: 2011/ 7/ 12
& Engine coolant
! Checking the coolant level
Check the coolant level at each fuel stop.
1. Check the coolant level on the outside
of the reservoir while the engine is cool.
2. If the level is close to or lower than the
LOW level mark, add coolant up to the
FULL level mark. If the reserve tank is
empty, remove the radiator cap and refill
as required.
3. After refilling the reserve tank and the
radiator, reinstall the caps and check that
the rubber gaskets inside the radiator cap
are in the proper position.
CAUTION
. Be careful not to spill engine
coolant when adding it. If coolant
touches the exhaust pipe, it may
cause a bad smell, smoke, and/or
a fire. If engine coolant gets on
the exhaust pipe, be sure to wipe
it off.
. Do not splash the engine coolant
over painted parts. The alcohol
contained in the engine coolant
may damage the paint surface.
! Changing the coolant
It may be difficult to change the coolant.
Have the coolant changed by your
SUBARU dealer if necessary.
The coolant should be changed according
to the maintenance schedule in the
Warranty and Maintenance Booklet.
Maintenance and service 11-11
11
Information Provided by:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Subaru Tribeca 2012 and is the answer not in the manual?

Subaru Tribeca 2012 Specifications

General IconGeneral
BrandSubaru
ModelTribeca 2012
CategoryAutomobile
LanguageEnglish

Related product manuals