SubGear XP-3G - 4 Gauge Mode

41
Gauge mode
English
4. GAUGE MODE
WARNING
In gauge mode ALL audible and visual alarms and attention messages are turned off.
In gauge mode Subgear XP-3G will display depth, dive time and max depth. By pressing
you can scroll from the max depth to the temperature, to the average depth, to the time
of day and back to the max depth. By pressing you can restart the stopwatch. This
generates a bookmark. Gauge mode does not support the calculation of no-stop time or
the supervision of decompression. Supervision of ppO
2
max and CNS O
2
% will also be
switched off. Subgear XP-3G will display no information about microbubble development.
The settings for the gas mixture, MOD and microbubble level cannot be set and the dive
planner cannot be selected.
Switching the gauge mode on and off
Gauge mode can be switched on and off at the surface, when there is no desaturation and
no-dive in gauge mode has been made in the last 48 hours.
WARNING
•Divesingaugemodeareperformedatyourownrisk!
•After diving in gaugemodeyoumustwaitforatleast48hoursbeforeusingadecompression
computer.
After diving in gauge mode, Subgear XP-3G can not be used as dive computer for 48 hours.
Procedure:
1. From the time of day display push or until the “ALGO” is displayed.
(If Subgear XP-3G shows “ – – – ” the gauge mode cannot be switched “on” or “off”.
Subgear XP-3G shows “ – – – ” for 48 hours after a dive in gauge mode and as long as
there is remaining desaturation after a dive in computer mode.)
2. Confirm with
that you wish to activate or deactivate the gauge mode. “deco”,
“gauge” or “apnea” starts flashing.
3. By pushing
or the mode will scroll between: Gauge, Deco (SCUBA diving)
or Apnea. Select: “Gauge”.
4. Confirm your settings with
.
Without confirmation the display will disappear after 3 minutes and your entries will not be
accepted.
Diving in gauge mode
The following information is displayed in gauge mode: