SubGear XP-3G - 3.3.2 Microbubble (MB) Level Setting; 3.4 Dive Functions

26
Diving with Subgear XP-3G
3.3.2 Setting the MB level
See chapter 6, ->46
3.3.3
Preparation for diving with 2 or 3 gas mixtures
See chapter 8, ->59
3.3.4 Preparation for diving with CCR
See page ->66
3.3.4 Preparation for the dive and function check
Switch on Subgear XP-3G by pushing and check the test display: Are all elements of
the display activated? Do not use Subgear XP-3G if the display does not show all elements.
When switching on Subgear XP-3G with , the test display will not appear.
WARNING
Checkthebatterycapacitybeforeeachdive->17.
3.4 Functions during the dive
3.4.1 Immersion
If the water contacts are deactivated (->90), switch on Subgear XP-3G before immersion.
WARNING
If you have chosen the option “Water contacts off” (“set 1” or Dive.Log), Subgear XP-3G will turn on
with a delay of up to 1 minute into the dive. This will affect functioning of the computer. Make sure
that the computer is on before starting the dive.
After immersion, starting at a depth of about 0.8m (3ft), all diving functions are monitored,
i.e. depth and
dive time displayed, max depth stored, saturation of tissues calculated, no-stop
time or decompression prognosis determined, ascent rate controlled and displayed and the
correctness of the decompression procedure supervised.
3.4.2 Setting bookmarks
During the dive you can create bookmarks in your dive profile by pressing
. The
logbook icon
appears for 4 seconds and an audible signal confirms the creation of the
bookmark. These bookmarks will be graphically displayed in the dive profile of Dive.Log.