SubGear XP-3G - 6.4.3 Decompression Obligation

50
Diving with microbubble (MB) levels
•No-stoptimerelativetoL0isshownbypressing3x
(see )
•RegardlessoftheMBlevel,wegenerallyrecommendtoperformaslowascent
duringthelastfewmetres/feet.
Level stop
STOP
NO
CNS O 2 %
DEPTH
DIVE TIME
Deepest level
stop depth
Total time
of ascent
Level stop
duration
Level stop icon
On entering the level stop phase, “NO STOP” disappears and the arrow
STOP
appears. The
STOP
arrow flashes for 8 seconds and an audible attention beep goes off. To complete the
dive without cascading to a lower MB level, all requested level stops must be observed.
The deepest level stop is displayed in metres (feet). The display “2: 3m ” (“2: 10ft”) means
that a level stop of 2 minutes at a depth of 3 metres (10 feet) has to be observed. Deco
information relative to L0 is shown on an alternate display (see ).
When a level stop has been finished, the next higher level stop – if present – is displayed.
When all level stops have been observed, the arrow
STOP
extinguishes and “NO STOP”
reappears. The indication of time shows the MB no-stop time again.
STOP
CNS O 2 %
DEPTH
DIVE TIME
4s
Level stop ignored