SubGear XP-3G - Switching SP1;SP2 to Bail-Out

72
CCR Diving
After immersion, Subgear XP-3G automatically starts the dive with SP1.
Time
Depth
SP2 SP1/2 SP1
Switching range form SP1 to SP2
WARNING
WhentheswitchdepthisreachedanaudiblewarninggoesoffandMODblinksaslongasthecurrentdepthis
belowMOD.BelowSP1MOD,SubgearXP-3GcalculatesaccordingtoSP1ppO
2
content; this may lead to long
decompression requirement since nitrogen fraction increases above the diluent content.
DEPTH
NO STOP
DIVE TIME
4s
Max Operating Depth MOD SP1 reached,
Switch to SP2
Procedure:
1. Switch your CCR from SP1 to SP2.
2. Start the change by pressing . “SP2”, its MOD (not allowed to go shallower) and the set ppO
2
is displayed.