Suffolk SS100 - Strake Fitting; Cutting and Gluing Rubber Insert

SS100 Build Manual (Export Edition) Rev 10 November 2013
Page 85
Figure 13 – Strake Fitting
Pos
itions for strakes:
• Rear end of strakes level and 83 mm forward of rear edge of door.
• First strake fitting - A 25 mm from edge of body.
• Second strake fitting - E 25 mm from wing beading, 30 mm if fitting before beading.
• Third strake fitting – C central between A and E.
• Forth strake fitting – B central between A and C.
• Fifth strake fitting – D central between C and E.
Cutting and gluing rubber insert:
Cut
“V” into rubber before bringing together with super glue.
A
B
C
D
E