SS100 Build Manual (Export Edition) Rev 10 November 2013
3.2 Parts List
Any items not ticked in the SUPPLIED column are not in stock and will follow shortly.
SECTION 1 CHASSIS BUILD UP
Page 1
DESCRIPTION
Donor car component package
Strip/prepare/paint donor components
Chassis painted + black powder coating
2 long stays + 2 short stays + 2 wing stays
Differential mountings x 3 (2 lowers often part of rear axle - 077)
Spare wheel carrier + spacers x3
Pedal shaft, washer, bolt & split pin.
Brake & clutch pedals + 2 tops + rubbers & Throttle pedal + brkt
Tie bars x 2 complete with bushes and rose joints
Handbrake assembly inc. cable
Prop-shaft (specify gearbox type)
Fuel tank + straps + rubber strips + drain bung
Fuel tank sender unit – bent to correct profile
Alloy radiator + Fan thermo switch + Electric fan fitted +15lb rad
cap
Radiator lower mounting rubbers x2 + overflow hose + bottom
hose
Andre Hartford dummy x2 + stars and dials
Servo + master cylinder + 4 spacers + hose & clips
Steering rack – modified long or short turret
Track rod ends x2 (metric or imperial)?
Rack mounting poly bush kit
Front shock absorber mounting plates x 2
Bolt on steering lock stops (fit with 022)
Front shock absorber spacers x 4
Front shocks + springs x 2 fitted together
Front brake flexible hoses + nuts x 2
Clutch flexible hose + nuts
Clutch master cylinder + pushrod
Brake pipe set – 11 piece
Brake light switch + copper washer
Brake unions 1 x 3way + 1 x 4way
Fuel line set + nut & olive + hose clips x6
Front lower wishbones x 1LH + 1RH
Front lower wishbone shafts x 2 + castle nuts & split pins
Front serrated washers x4 + thin washers x2
Front lower wishbone castor spacers (SS) x2
Front lower wishbone bushes x4
Front bottom ball joints x2
Front upper wishbones x4 (curly or straight)?
Front upper wishbone rubber bushes x4