*1 The protrusion part is not included.
*2 With Sumitomo identical fiber (in room temperature. Varies depending on the condition of fiber.)
*3 With the power supply module in room temperature (20°C). If the battery module is used, the
heating cycle time varies depending on the temperature and the remaining battery capacity.
*4 With a new battery, 1 splice cycle time (splice + protection) completes in 90 seconds, in room
temperature. A hot jacket remover is not used. Splice & heat cycles may vary depending on the
operating environment.
*5 Performed on the fiber stage after splicing.
*6 Non-condensing
*7
The Battery module storage temperature range: -20°C ~ +50°C (if stored for less than 3 months)
-20°C ~ +30°C (if stored for less than 1 year)
56
To Next Page
Loading...