Sun Microsystems Netra 240 - FIGURE 2-5 Removing the Server Cover

28 Netra 240 Server Service Manual • June 2004
FIGURE 2-5 Removing the Server Cover
3. Grasp the cover at the sides and slide it toward the back of the server, then lift it
up and away from the server (
FIGURE 2-5).
4. Hang the cover on the Netra 240 server, if necessary (FIGURE 2-6).
You must open the rotating service module to hang the cover on the server. Refer to
“Accessing Rotating Service Module Components” on page 30 for those instructions.
To hang the cover downward, open the front bezel by gripping the bezel at the two
finger holds and rotating it down to its open position (
FIGURE 2-4).