Chapter 4 Removing and Replacing Rotating Service Module Components 61
System Configuration Card Reader
Cluster
The system configuration card reader cluster includes the DVD drive bay, the rotary
switch, and the system configuration card bay.
Removing the System Configuration Card Reader
Cluster
1. Power off the server.
See “Powering Off the Server” on page 22.
2. Grip the bezel at the two finger holds and rotate it down to its open position
(
FIGURE 2-4).
3. Remove the system configuration card from the system configuration card reader.
See “Removing a System Configuration Card” on page 38.
4. Remove the DVD-ROM drive from the server.
See “Removing a DVD Drive” on page 46.
5. Remove the server cover.
See “Removing the Server Cover” on page 27.
6. Open the rotating service module.
See “Opening the Rotating Service Module” on page 30.
7. Ensure that the server is properly grounded.
See “Avoiding Electrostatic Discharge” on page 32.
8. Lift the SCSI/IDE cable clamp out of the way (FIGURE 4-4).
The clamp has a green cap that is attached to the chassis, and holds the SCSI
interface cable and the IDE cable.
To Next Page
Loading...
