Sun Microsystems Netra 240 - Installing the Alarm Board; FIGURE 4-1 Removing the Alarm Board

Chapter 4 Removing and Replacing Rotating Service Module Components 55
FIGURE 4-1 Removing the Alarm Board
7. Lift the alarm board up and out of the server.
Installing the Alarm Board
1. Place the alarm board into position in the rotating service module (FIGURE 4-1).
2. Tighten the captive screw to secure the alarm board to the rotating service module
(
FIGURE 4-1).
3. Connect the ribbon cable and the cable to the SCSI board to the alarm board and
set the securing tabs (
FIGURE 4-1).
4. Close the rotating service module.
See “Closing the Rotating Service Module” on page 31.
Alarm board
Captive screw
Securing tabs