Sun Microsystems Netra 240 - Installing the SCSI Interface Board

60 Netra 240 Server Service Manual • June 2004
Installing the SCSI Interface Board
1. When standing in the front of the server, place the SCSI interface board into
position in the rotating service module (
FIGURE 4-3).
Align the six tabs on the SCSI interface board, then slide the assembly down and to
the right to lock into position.
2. Tighten the captive screw to secure the board to the rotating service module
(
FIGURE 4-3).
3. Attach and route the bezel cables, the SCSI interface cable, the DVD power/I
2
C
interface ribbon cable, the alarm board cable, and the SCSI interface board power
cable to the SCSI interface board (
FIGURE 4-3).
4. Close the rotating service module.
See “Closing the Rotating Service Module” on page 31.
5. Install the server cover.
See “Installing the Server Cover” on page 29.
6. Grip the bezel at the two finger holds and rotate it down to its open position
(
FIGURE 2-4).
7. Install the hard drives back into the drive bays.
See “Installing a Hard Drive” on page 43. Refer to the notes that you took earlier in
the procedure to install the hard drives back into the proper bays.
8. Power on the server.
See “Powering On the Server” on page 20.