76 Netra 240 Server Service Manual • June 2004
PCI Cards
The Netra 240 server supports one full-length 64-bit PCI card running at 33 MHz or
66 MHz (PCI0), and two half-length 64-bit PCI cards running at 33 MHz (PCI1 and
PCI2). They are 3.3V (PCI 0) and 5V (PCI 1-2). The server can support a maximum of
25W per card, but no more than 45W spread over all three slots. The PCI cards are
not hot-swappable.
Note – Add PCI cards to the Netra 240 server in order from PCI 0 to PCI 2. This
corresponds to populating the PCI slots from bottom to top.
The following procedures describe how to remove and install individual PCI cards
into the Netra 240 server.
■ To install one or more new PCI cards in your server, go to “Installing a PCI Card”
on page 80.
■ To replace a faulty PCI card in the server, first go to “Removing a PCI Card” on
page 77 to remove the PCI card, then go to “Installing a PCI Card” on page 80 to
install the replacement PCI card.
To Next Page
Loading...
