Chapter 5 Removing and Replacing Miscellaneous Internal Components 75
1. Prepare the server for servicing, if you have not done so already:
a. Power off the server.
See “Powering Off the Server” on page 22.
b. Remove the server cover.
See “Removing the Server Cover” on page 27.
c. Close the rotating service module.
See “Opening the Rotating Service Module” on page 30.
d. Ensure that the server is properly grounded.
See “Avoiding Electrostatic Discharge” on page 32.
e. Rotate the air duct and rear fan assembly up.
See “Removing or Rotating the Air Duct and Rear Fan Assembly” on page 68.
Note that you only have to rotate the assembly up, not remove it from the server.
2. Locate the correct memory socket (FIGURE 5-3).
3. Ensure that the socket latches are open.
4. Press the memory module in the memory socket.
5. Press down until the socket latches snap into place.
6. Close the air duct and rear fan assembly.
See “Installing or Closing the Air Duct and Rear Fan Assembly” on page 70.
7. Close the rotating service module.
See “Closing the Rotating Service Module” on page 31.
8. Install the server cover.
See “Installing the Server Cover” on page 29.
9. Power on the server.
See “Powering On the Server” on page 20.
To Next Page
Loading...
