9
Carrier Requirements
The mounting structure where the charger is installed must comply with local/na-
tional standards and guidelines.
• The carrier should be solid enough to bear 4.5 times the weight of the charger.
• The carrier should be suitable for the dimensions of the charger.
• The surface of the carrier must be fire-resistant.
Angle Requirements
• Install the charger vertically.
• Do not install the charger horizontally, tilted or upside down.
• Do not install the charger on a tilted surface.
2.2 Unpacking and Inspection
After receiving the product, check whether the appearance and structural parts of
the device are damaged, and check whether the packing list is consistent with the
actual ordered product. If there are problems, do not install the device and contact
your distributor first. If the problem persists, contact SUNGROW in time.
User Manual 2 Installation
To Next Page
Loading...
Need help?
General