2
• The safety instructions in this manual are only supplements and cannot cover
all the precautions that should be followed. Perform operations considering ac-
tual onsite conditions.
• SUNGROW shall not be held liable for any damage caused by violation of gen-
eral safety operation requirements, general safety standards, or any safety in-
struction in this manual.
• When installing, operating, and maintaining the product, comply with local laws
and regulations. The safety precautions in this manual are only supplements
to local laws and regulations.
• During the product transport, installation, wiring, maintenance, etc., the materi-
als and tools prepared by users must meet the requirements of applicable local
laws and regulations, safety standards, and other specifications. SUNGROW
shall not be held liable for any damage to the product caused by the adoption
of materials and tools that fail to meet the above-mentioned requirements.
• Operations on the product, including but not limited to, handling, installing, wir-
ing, powering on, maintenance, and use of the product, must not be performed
by unqualified personnel. SUNGROW shall not be held liable for any damage
to the product resulting from operations done by unqualified personnel.
• Where the transport of the product is arranged by users, SUNGROW shall not
be held liable for any damage to the product that is caused by users them-
selves or the third-party transport service providers designated by the users.
• SUNGROW shall not be held liable for any damage to the product caused by
the negligence, intent, fault, improper operation, and other behaviors of users
or third-party organizations.
• SUNGROW shall not be held liable for any damage to the product arising from
reasons unrelated to SUNGROW.
1.1 Unpacking and Inspection
• Check all safety signs, warning labels and nameplates on devices.
• The safety signs, warning labels and nameplates must be clearly visible and
cannot be removed or covered before the device is decommissioned.
After receiving the product, check whether the appearance and structural parts of
the device are damaged, and check whether the packing list is consistent with the
actual ordered product. If there are problems with the above inspection items, do
not install the device and contact your distributor first. If the problem persists, con-
tact SUNGROW in time.
1 Safety Instructions User Manual
To Next Page
Loading...
Need help?
General
