EasyManuals Logo

Sungrow SG50CX User Manual

Sungrow SG50CX
129 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
20
4
Mechanical Mounting
Respect all local standards and requirements during mechanical installation.
4.1 Safety During Mounting
Make sure there is no electrical connection before installation.
Before drilling, avoid the water and electricity wiring in the wall.
For specific requirements for the installation environment, see
""4.2.1 Installation
Environment Requirements""
. In case the environment where the device is installed
does not meet the requirements, SUNGROW shall not be held liable for any prop-
erty damage arising therefrom.
Improper handling may cause personal injury!
When moving the inverter, be aware of its weight and keep the balance to pre-
vent it from tilting or falling.
Wear proper protective equipment before performing operations on the inverter.
The bottom terminals and interfaces of the inverter cannot directly contact the
ground or other supports. The inverter cannot be directly placed on the ground.
When installing devices, ensure that no device in the system causes it hard for the
DC switch and the AC circuit breaker to act or hinders maintenance personnel from
operating.
If drilling is required during installation:
Wear goggles and protective gloves when drilling holes.
Make sure to avoid the water and electricity wiring in the wall before drilling.
Protect the product from shavings and dust.

Table of Contents

Other manuals for Sungrow SG50CX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sungrow SG50CX and is the answer not in the manual?

Sungrow SG50CX Specifications

General IconGeneral
Max. DC Voltage1100 V
MPPT Voltage Range200 V - 1000 V
Max. Input Current per MPPT26 A
Number of MPPTs4
Rated AC Output Power50 kW
Max. AC Output Current76 A
Frequency50 Hz / 60 Hz
Efficiency98.6%
Start Voltage200 V
Number of DC Inputs per MPPT2
Max. AC Apparent Power55 kVA
AC Voltage Range310 V - 480 V
Power Factor at Rated Power1
Adjustable Power Factor Range0.8 leading - 0.8 lagging
THDi< 3%
DC SwitchYes
AC Surge ProtectionType II
DC Surge ProtectionType II
Protection ClassI
Cooling MethodSmart forced air cooling
Protection DegreeIP66
Protection LevelIP66
Operating Temperature Range-25°C to +60°C
Humidity0-100%
AC Output Voltage3 / N / PE, 220 V / 380 V, 230 V / 400 V

Related product manuals