Sunmi Blink - Stability of Induction Time 稳定感应时间; Output Interval of the same Code 相同读码延时



11
*高灵敏度 High
(0x01)
中灵敏度 Middle
(0x02)
低灵敏度 Low
(0x03)
Stability of Induction Time 稳定感应时间
Stability of induction time, Default: 500ms, unit:100ms, range: 0-9900ms
进入检测环境前稳定的时间，默认：500ms，单位：100ms，范围：0-9900ms
稳定感应时间 Stability of Induction Time
For example:
Set stability of induction time is 200ms
Scan stability of induction time setting code,then scan Numeric Bar Codes 0 and 2
如：
设置稳定感应时间 200ms。
先扫描稳定感应时间设置码，再扫描
数字设置码 0 和 2。
Set stability of induction time is 1500ms
Scan stability of induction time setting code,then scan Numeric Bar Codes 1 and 5
设置稳定感应时间 1500ms
先扫描稳定感应时间设置码，再扫描
数字设置码 1 和 5。
Output Interval of The Same Code 相同读码延时
To avoid reading the same barcode multiple times in continuous mode and automatic induction mode, set
the scan engine to allow reading the same barcode after a delay.
Output interval of the same code is to refuse to read the same barcode within the set length of time.
Default: 500ms,unit:100ms,range: 0-9900ms
To set output interval of the same code, scan the bar code below. Next scan two Numeric Bar Codes in
appendix that correspond to the desired time-out. Single digit values must have a leading zero. For example,
to set a time-out of 0.5 seconds, scan the bar code below, then scan the “0” and “5” bar codes. To change the
selection or cancel an incorrect entry, scan Cancel in appendix.