Sunmi Blink - Code 93; Enable;Disable Code 93 使能;禁止 Code 93; Set Lengths for Code 93 设置 Code 93 长度



34
Code 93
Enable/Disable Code 93 使能/禁止 Code 93
To enable or disable Code 93, scan the appropriate bar code below.
扫描以下相对应的条码来设置使能或禁止Code 93。
Enable Code 93使能Code 93
(0x01)
*Disable Code 93禁止Code 93
(0x00)
Set Lengths for Code 93 设置 Code 93 长度
The length of a code refers to the number of characters (i.e., human readable characters), including
check digit(s) the code contains. Lengths for Code 93 may be set for any length, one or two discrete
lengths, or lengths within a specific range. To set lengths via serial commands, see Setting Code Lengths
Via Serial Commands .
一个代码的长度指的是此代码所包含的字符数（如：人类可读的字符），包括校验码。Code 93 可设置成
任意的长度，一个或两个单独的长度，或者在特定范围内的长度。通过串行命令设置长度，见附录中的
通过串
行命令设置代码长度
。
One Discrete Length - Select this option to decode only those codes containing a selected length. For
example, select Code 93 One Discrete Length, then scan 1, 4, to limit the decoding to only Code 93 symbols
containing 14 characters. Numeric Bar Codes is in appendix. To change the selection or cancel an incorrect
entry, scan Cancel in appendix.
一个单独长度-选择此长度可用来解码那些包含既定长度的代码。例如，选择Code 93 One Discrete
Length，然后扫描1,4，来解码包含14个字符的Code 93码制。
数字设置码 见附录，改变选择或者取消一个不
正确的输入设置，扫描附录中的
取消条形码 。
Code 93 - One Discrete Length Code 93 –一个单独长度
Two Discrete Lengths - Select this option to decode only those codes containing two selected lengths.
For example, select Code 93 Two Discrete Lengths, then scan 0, 2, 1, 4, to limit the decoding to only Code
93 symbols containing 2 or 14 characters. Numeric Bar Codes is in appendix. To change the selection or
cancel an incorrect entry, scan Cancel in appendix.
两个单独的长度-选择此长度可用来解码那些包含两个既定长度的代码。例如，选择Code 93 Two Discrete
Lengths，然后扫描0，2，1，4，只可用来解码包含2个或者14个字符的Code 93码制。
数字设置码 见附录，
改变选择或者取消一个不正确的输入设置，扫描附录中的
取消条形码 。