Sunmi Blink - Code 11; Enable;Disable Code 11



35
Code 93 - Two Discrete Lengths Code 93 –两个单独长度
Length Within Range - This option sets the unit to decode a code type within a specified range. For
example, to decode Code 93 symbols containing between 4 and 12 characters, first scan Code 93 Length
Within Range, then scan 0, 4, 1 and 2 (single digit numbers must always be preceded by a leading zero).
Numeric Bar Codes is in appendix. To change the selection or cancel an incorrect entry, scan Cancel in
appendix..
特定范围内的长度-选择此项解码指定范围的代码。例如，解码包含4个到12个字符的Code 93，首先扫描
Code 93 Length Within Range，然后扫描0，4，1，和2（不足3位用0补齐）。
数字设置码 见附录，改变选
择或者取消一个不正确的输入设置，扫描附录中的
取消条形码 。
Code 93 - Length Within Range Code 93 -特定范围内的长度
Any Length - Scan this option to decode Code 93 symbols containing any number of characters.
任意长度-扫描此项可解码包含任意字符的Code 93码制
Code 93 - Any Length Code 93 –任意长度
Code 11
Enable/Disable Code 11
To enable or disable Code 11, scan the appropriate bar code below.
扫描以下相对应的条码来设置使能或禁止Code 11。
Enable Code 11使能Code 11
(0x01)
*Disable Code 11禁止Code 11
(0x00)