Sunmi Blink - Enable;Disable Code 39 Full ASCII 使能;禁止 Code 39 Full ASCII; Code 39 Transport Start Character and Terminator Code 39 传送起始符与终止符



32
Scan this symbol to transmit data without the check digit.
扫描此条码传输不带有校验码的数据。
*Do Not Transmit Code 39 Check Digit (Disable)
不传输Code 39校验位（禁止）
(0x00)
Enable/Disable Code 39 Full ASCII 使能/禁止 Code 39 Full ASCII
Code 39 Full ASCII is a variant of Code 39 which pairs characters to encode the full ASCII character
set. To enable or disable Code 39 Full ASCII, scan the appropriate bar code below.
Code 39 Full ASCII是由Code 39演变而来的，是由双字符编码成full ASCII字符设置。
扫描以下相对应的条码来使能或者禁止Code 39 Full ASCII。
See Table 1-1 for the mapping of Code 39 characters to ASCII values.
见
表 1-1Code 39字符对ASCII值的映射。
Enable Code 39 Full ASCII使能Code 39 Full ASCII
(0x01)
*Disable Code 39 Full ASCII禁止Code 39 Full ASCII
(0x00)
NOTE Trioptic Code 39 and Code 39 Full ASCII cannot be enabled simultaneously. If you get an
error beep when enabling Code 39 Full ASCII, disable Trioptic Code 39 and try again.
注：Trioptic Code 39 和 Code 39 Full ASCII不能同时使能，若使能Code 39 Full ASCII时发出错误的提示
声，先禁止Trioptic Code 39，然后再试一次。
Code 39 Transport Start Character and Terminator Code 39 传送起始符与终止符

Disable *禁止
(0x00)