Sunmi Blink - Interleaved 2 of 5;Itf;交叉 25 码; Enable;Disable Interleaved 2 of 5 使能;禁止 Interleaved 2 of 5; Set Lengths for Interleaved 2 of 5 Interleaved 2 of 5 长度设置



38
*Do Not Transmit Code 11 Check Digit(s) (Disable) 不传输Code 11校验位（禁止）
(0x00)
NOTE Code 11 Check Digit Verification must be enabled for this parameter to function.
注：为了使此参数功能实现，必须使能Code 11校验码验证
Interleaved 2 of 5/ITF/交叉 25 码
Enable/Disable Interleaved 2 of 5 使能/禁止 Interleaved 2 of 5
To enable or disable Interleaved 2 of 5, scan the appropriate bar code below.
扫描以下相对应的条码来设置使能或禁止Interleaved 2 of 5。
*Enable Interleaved 2 of 5使能Interleaved 2 of 5
(0x01)
Disable Interleaved 2 of 5禁止Interleaved 2 of 5
(0x00)
Set Lengths for Interleaved 2 of 5 Interleaved 2 of 5 长度设置
The length of a code refers to the number of characters (i.e., human readable characters), including
check digit(s) the code contains. Lengths for I 2 of 5 may be set for any length, one or two discrete lengths, or
lengths within a specific range. To set lengths via serial commands, see Setting Code Lengths Via Serial
Commands.
NOTE When setting lengths, single digit numbers must always be preceded by a leading zero.
一个代码的长度指的是此代码所包含的字符数（如：人类可读的字符），包括校验码。I 2 of 5可设置成任
意的长度，一个或两个单独的长度，或者在特定范围内的长度。通过串行命令设置长度，见附录中的
通过串行
命令设置代码长度
。
注：当设置长度时，不足3位的数前面必须要用0补齐。
One Discrete Length - Select this option to decode only those codes containing a selected length. For
example, select I 2 of 5 One Discrete Length, then scan 1, 4, to decode only I 2 of 5 symbols containing 14
characters. Numeric Bar Codes is in appendix. To change the selection or cancel an incorrect entry, scan
Cancel in appendix.
一个单独长度-选择此长度可用来解码那些包含既定长度的代码。例如，选择I 2 of 5 One Discrete Length，
然后扫描1,4，来解码包含14个字符的I 2 of 5码制。
数字设置码 见附录，改变选择或者取消一个不正确的输入
设置，扫描附录中的
取消条形码 。