Sunmi Blink - Msi;Msi Plessey; Enable;Disable MSI 使能;禁止 MSI; Set Lengths for MSI MSI 长度设置



50
(0x01)
MSI/MSI PLESSEY
Enable/Disable MSI 使能/禁止 MSI
To enable or disable MSI, scan the appropriate bar code below.
扫描以下相对应的条码来设置使能或禁止MSI。
Enable MSI使能MSI
(0x01)
*Disable MSI禁止MSI
(0x00)
Set Lengths for MSI MSI 长度设置
The length of a code refers to the number of characters (i.e., human readable characters) the code
contains, and includes check digits. Lengths for MSI can be set for any length, one or two discrete lengths, or
lengths within a specific range. See Table 1-1 for ASCII equivalents. To set lengths via serial commands, see
Setting Code Lengths Via Serial Commands.
一个代码的长度指的是此代码所包含的字符数（如：人类可读的字符），包括校验码。MSI可设置成任意
的长度，一个或两个单独的长度，或者在特定范围内的长度。ASCII对照表见
表 1-1。通过串行命令设置长度，
见附录中的
通过串行命令设置代码长度 。
One Discrete Length - Select this option to decode only those codes containing a selected length.
For example, select MSI Plessey One Discrete Length, then scan 1, 4, to decode only MSI Plessey
symbols containing 14 characters. Numeric Bar Codes is in appendix. To change the selection or cancel
an incorrect entry, scan Cancel in appendix.
一个单独长度-选择此长度可用来解码那些包含既定长度的代码。例如，选择MSI Plessey One Discrete
Length，然后扫描1,4，来解码包含14个字符的MSI Plessey码制。
数字设置码 见附录，改变选择或者取消一个
不正确的输入设置，扫描附录中的
取消条形码 。
MSI - One Discrete Length MSI -一个单独长度
Two Discrete Lengths - Select this option to decode only those codes containing two selected
lengths. For example, select MSI Plessey Two Discrete Lengths, then scan 0, 6, 1, 4, to decode only MSI
Plessey symbols containing 6 or 14 characters. Numeric Bar Codes is in appendix. To change the selection
or cancel an incorrect entry, scan Cancel in appendix.