Sunmi Blink - Discrete 2 of 5;Industrial 2 of 5;Ind25;工业 25 码; Enable;Disable Discrete 2 of 5 使能;禁止 Discrete 2 of 5; Set Lengths for Discrete 2 of 5 Discrete 2 of 5 长度设置



41
Convert I 2 of 5 to EAN-13
转换I 2 of 5为EAN-13（使能）
(Enable) (0x01)
*Do Not Convert I 2 of 5 to
EAN-13
不转换I 2 of 5为EAN-13（禁止）(Disable)
(0x00)
Discrete 2 of 5/Industrial 2 of 5/IND25/工业 25 码
Enable/Disable Discrete 2 of 5 使能/禁止 Discrete 2 of 5
To enable or disable Discrete 2 of 5, scan the appropriate bar code below.
扫描以下相对应的条码来设置使能或禁止Discrete 2 of 5。
Enable Discrete 2 of 5使能Discrete 2 of 5
(0x01)
*Disable Discrete 2 of 5禁止Discrete 2 of 5
(0x00)
Set Lengths for Discrete 2 of 5 Discrete 2 of 5 长度设置
The length of a code refers to the number of characters (i.e., human readable characters), including
check digit(s) the code contains. Lengths for D 2 of 5 may be set for any length, one or two discrete
lengths, or lengths within a specific range. To set lengths via serial commands, see Setting Code
Lengths Via Serial Commands.
一个代码的长度指的是此代码所包含的字符数（如：人类可读的字符），包括校验码。D 2 of 5可设置成
任意的长度，一个或两个单独的长度，或者在特定范围内的长度。通过串行命令设置长度，见附录中的
通过串
行命令设置代码长度
。
One Discrete Length - Select this option to decode only those codes containing a selected length. For
example, select D 2 of 5 One Discrete Length, then scan 1, 4, to decode only D 2 of 5 symbols containing 14
characters. Numeric Bar Codes is in appendix. To change the selection or cancel an incorrect entry, scan
Cancel in appendix.