Sunmi Blink - Codabar; Enable;Disable Codabar 使能;禁止 Codabar; Set Lengths for Codabar Codabar 长度设置



47
Standard 25 - Length Within Range 特定范围内的长度
Any Length - Scan this option to decode Standard 25 symbols containing any number of characters.
NOTE Selecting this option may lead to misdecodes for Standard 25 codes.
任意长度-扫描此项可解码包含任意字符的Standard 25码制
注：选择此项可能导致 Standard 25 错误解码。
Standard 25 - Any Length 任意长度
Codabar
Enable/Disable Codabar 使能/禁止 Codabar
To enable or disable Codabar, scan the appropriate bar code below.
扫描以下相对应的条码来设置使能或禁止Codabar。
Enable Codabar 使能Codabar
(0x01)
*Disable Codabar 禁止Codabar
(0x00)
Set Lengths for Codabar Codabar 长度设置
The length of a code refers to the number of characters (i.e., human readable characters), including
check digit(s) the code contains. Lengths for Codabar may be set for any length, one or two discrete
lengths, or lengths within a specific range. To set lengths via serial commands, see Setting Code Lengths
Via Serial Commands.
一个代码的长度指的是此代码所包含的字符数（如：人类可读的字符），包括校验码。MSI可设置成任意
的长度，一个或两个单独的长度，或者在特定范围内的长度。通过串行命令设置长度，见附录中的
通过串行命
令设置代码长度
。
One Discrete Length - Select this option to decode only those codes containing a selected length. For
example, select Codabar One Discrete Length, then scan 1, 4, to decode only Codabar symbols containing
14 characters. Numeric Bar Codes is in appendix. To change the selection or cancel an incorrect entry, scan
Cancel in appendix.