(1) Setting the chain sewing environment
A. Press MODE key.
B. Move to “ 1. Parameter Set ”by using direction
keys .
C. If you press ENTER key, you can get the
screen like a figure on the right side, then input
[0][5][4].
※ Appendix :
Refer “Parameter number related to general sewing.”
D. After pressing ENTER key, input the
number of chain sewing you want by using
direction keys . Here we input 2 for example.
<< Main Menu >>
1. Parameter Set
2. Program
3. Bobbin Wind
<Parameter Set>
PARA No : 054
054.Chain Number
2
E. Press ENTER key. If you press ENTER
key again, you can get the screen like a figure
on the right side, then input [0][5][5].
※ Appendix :
Refer “Parameter number related to general sewing.”
<Parameter Set>
PARA No : 055
G. After pressing ENTER key, and press ESC
key to back to the initial screen.
F. Input if you want an automatic operation or
manual for the change of chain number by using
direction keys press ENTER key. And
then, after pressing ENTER key.
055:Chain Select
1.MANUAL
2.AUTO <-
3.EXTERNAL
<< Main Menu >>
1. Parameter Set
2. Program
3. Bobbin Wind
To Next Page
Loading...
